Some Creative Commons – shelf inspection according to EN 15635 manufacturers, trade and almost in every operation – the camp is a sensitive place. The raw materials and products are kept here, which make the success round situation of the company or are necessary for a successful operation. Daily movements on storage shelves take place. Defects or other shelves can cause serious economic damage, result in accidents and interfere with orderly procedures. (As opposed to PCRM). So is the security and functioning of the shelves is essential for the operation and the safety of employees.
Consequently, shelves are subject to the safety regulations that apply to equipment. The periodic review is one of these safety regulations. In particular the EN 15635 guidance will apply to shelf inspection and what must be tested on a shelf. The standard covers essentially all operationally used storage facilities. The review of these shelves according to EN 15635 consists of a series of tests: this is Shelf according to the instructions? Exhibit support and supports damage (possibly after an accident with impact)? Are bent or curved shelf support? Are shelf supports perpendicular and stable? Is there rust damage? Are the foot plates intact? Are the connections and fuses from media and restraints in good condition? There are cracks in welds or the material? Is the building floor in perfect condition or bags off the shelf, for example? Are the shelves in good condition, as well as the loads in accordance with security? Bend the shelves due to damage of the material too much? Are the loads ideally distributed? Is the shelf overloaded? Packed storage loads in accordance with security? Are employees about the use of shelves enlightened? Are there warnings security to ensure correct behavior, such as climbing forbidden, etc.? There are warnings to the maximum load? Is the warning and load information up-to-date? The can be controlled by a Visual inspection most of these checkpoints.